The Use Of The 1 inch Belt Sander

1 Inch Belt Sander1 inch belt sander is a specialized tool, and it is not practical and utility like a traditional belt sander. In fact, one inch belt sander is indispensable. It can accomplish the tasks that else belt sander cannot do.

The difference between 1 inch belt sander and a traditional belt sander

Well, as you can tell from the name, the sanding belt is only 1 inch wide. So it doesn’t allow you to sand a wide area at one time. It does allow you to exercise in tight spaces and at clumsy angles, which is something you definitely cannot do with a traditional belt sander.

The role of a 1 inch belt sander

This kind of belt sander is fitted for anything from building boats to sanding in tight spaces. The operability is the main advantage of using a one inch belt sander. It allows you to shape the piece of wood as well as sand it. You need this when doing very precise work that you wouldn’t accomplish your task by a jigsaw or hacksaw. If you need to be precise, then this is the tool for you because sanding allows you to be very slow. When you use it to adjust the size of the wood, you need it to be perfect. By using a 1 inch belt sander, you’ll never have to waste wood.

The use of the one inch belt sander

Before you put the electrical plug into a 110 volt socket, you’d better put on eye protection. Then you can turn the sander on by pressing the “On/Off” switch to the “On” position.

Similarly, before it begins to operate, you should allow the sander motor and sanding belt to run for several minutes to acquire operating temperature.

Also, you need to watch the abrasive belt run on the sander. It should remain fixed midway between the left and right edges of the top tracking pulley. This adjustment is pre-set at the factory. If the belt is not correctly in line and tends to lean toward one side of the pulley, adjustment is required.

The riangular belt-tracking adjustment handle is black, and is located near the top of the machine, on the rear side. When you are facing the front of the sander, turning the handle clockwise will cause the abrasive belt to gradually move to the right. Turning the handle counterclockwise will cause the belt to gradually move to the left.

It takes 30 seconds for the abrasive belt to balance its new position. After that, you need to correct the belt tracking again. Please remember, the goal is to have the abrasive belt remain fixed exactly midway between the sides of the top tracking pulley.

To sum up, ensure that you get a 1 inch belt sander with a dust collector on it. Even though it’s got a narrow belt, you’d be surprised at the amount of sawdust it can throw up. Getting a model with a dust collector will help minimize dust in the air and save you clean-up time afterwards.